+086-15305925923

K-WANG

Service expert in industrial control field！
English 简体中文
Product
Article
NameDescriptionContent
Adequate Inventory, Timely Service
pursuit of excellence 
Ship control system
Equipment control system
Power monitoring system
Current position:
Home >> GE >> GE 8041-CC-35 Carrier extension cable, 0.35m
新闻动态
newS
   
Brand

GE 8041-CC-35 Carrier extension cable, 0.35m

From:ABB | Author:Wang | Time :2025-01-09 | 526 visit: | 🔊 Click to read aloud ❚❚ ▶ | Share:

GE 8041-CC-35 Carrier extension cable, 0.35m

The ELFD Controller Carrier provides a mounting platform for up to
two SafetyNet Controllers (8851-LC-MT). It can also accommodate a
Power Supply Monitor module (8410-NS-PS) which can monitor the
health of up to two 8913-PS-AC, four 8914-PS-AC power supplies
and the 12V supply to Intrinsically Safe Modules (when these are
used). For each Controller there is a serial port connector and a
manually operated "“Change State” button. The Carrier also
provides terminals that are used when earth leakage fault detection
is required.
CARRIER SPECIFICATION
See also System Specification
CARRIER MOUNTING MODULES
SafetyNet Controller (x2) ......................................8851-LC-MT
Power Supply Monitor Module ..............................8410-NS-PS
ELECTRICAL CONNECTIONS
Railbus connector ........................................................male out
Serial port connectors........................9-pin, D-type (female) (x2)
Power Fail connections ........................screw terminals (x7 pairs)
Ground connection ..................................M4 screw terminal (x1)
BFP0V connection ....................................M4 screw terminal (x1)
Earth leakage fault detection connections
..................................................................screw terminals (1 pair)
System Power connections......................................6-Pin (male)
(Note: this does not provide power to the SafetyNet Controllers)
MECHANICAL
Dimensions ................................200 (w) x 253 (d) mm (footprint)
Height ..............................................28 mm (top of circuit board)
.............................................................................55 mm (overall)
Weight ..............................................................1.43 kg (approx.)
Mounting methods ......................................flat panel (4 fixings)
USER CONTROLS
Two “ change state” buttons, one for each SafetyNet Controller, are
provided on the carrier. The state change depends upon the
controller state before the button is pressed. See table below for
effects.
Controller Carrier
ELFD Controller Carrier 8751-CA-NS
State Effect
Master Change to standby if current standby is healthy
Standby Change to offline state
Backup Re-synchronise and return to standby


EARTH LEAKAGE FAULT DETECTION
SYSTEM POWER SUPPLY CONNECTIONS
Pin # Function
1 0V
2 NC
3 Tx/Rx (+)
4 Tx/Rx (+)
5 Tx/Rx (-)
6 Tx/Rx (-)
7 NC
8 NC
9 0V
Terminal External Power
1 No connection
2 0V
3 +12V
4 +12V
5 0V
6 No connection
Two pairs of System Power supply connections (terminals 2/3 and
terminals 4/5) are provided for wiring a redundant pair of 8913-PSAC power supplies.
Note: The Controllers do not draw their power from these
connections, they are supplied with Controller Power via connections
on the Controllers themselves.
The GND terminal must always be connected to the main instrument
earth or the ‘star-point’ bus-bar. (Note: the 0V of the 8913-PS-AC
power supplies is GND).
The BFP0V terminal must always be connected to 0V of the 8914-PSAC power supplies.
Controller Carrier
When earth leakage fault detection is NOT required, a link should be
made - as shown below - between the BFP0V and GND connection
studs. Note: the BFP0V connection stud must still be connected to
Bussed Field Power 0V, marked “-” on the 8914-PS-AC power supply,
and the GND connection must still be connected to ground.
When earth leakage fault detection IS required, then the terminals of
connector CON12 must be wired to a channel of an 8810-IO-DC
module - as shown below - that has been configured for earth
leakage. Note: earth leakage fault detection can only operate when
BFP0V and all field wiring and field instruments are isolated from
ground (GND).
  • ABB 5SHX1445H0002 Power Semiconductor Module
  • ABB CI853-1 Communication Interface Module
  • ABB CI858-1 Communication Interface Module
  • ABB PM861K01 Processor Unit
  • ABB REM610 Motor Protection Relay
  • ABB 5SDF1045H0002 Power Semiconductor Module
  • Lilaas R01TS10A0H03-00 Marine Control Lever Module
  • Metso 1H13767C-3 - Paper Pinion Hand Guide Bevel
  • Metso LK-2101 - Linkage Kit
  • Metso A413510 - Rack Enclosure 21 Slots
  • Metso ND9106HU-K - Intelligent Valve Controller
  • Metso D201190L - AO4H Analog Module
  • Metso WIN1011187 - Top Slitter Assembly
  • Metso 251920 - Automation Component
  • Metso LK-1871 - Linkage Kit
  • Metso SE200N529 - XP Power Supply 115/230 VAC
  • Metso Shadow Brown Fleece - Harkila Half Zip Sweater
  • Metso DI8P - Valmet Digital Input Module
  • Metso DO8S0 - Valmet Digital Output Module
  • Metso AO8C - Valmet Analog Output Module
  • Metso AO4H - Valmet Analog Output Module
  • Metso AI8C - Valmet Analog Input Module
  • Metso PDCF2529 - Shaft Sleeve
  • Metso ST2.8 - Lokotrack Owners Manual & Parts Book
  • Metso 500836-M1 - Impeller Pump Release Collar Assembly
  • Metso RKN 33 XT - Valve Service Kit Pack
  • Metso PDCH2539 - Shaft Sleeve
  • Metso LK-2017 - Actuator Linkage
  • Metso N88409030 - Hammer Screw Jaw Crusher M48X970
  • Metso 181538 - IOP365 Isolated Analog Input Module
  • Metso 10691-04 - Charging Kit Olear/Parker
  • Metso QX4SB02SDM - Automation Component
  • Metso VAL0062567 - Pneumatic Cylinder 250 Psi
  • Harkila Metso Full Zip - Fleece Jacket Willow Green
  • Metso AM1-389 829-0010-218 - Bracket for 3+4 in Ball Valve
  • Metso D200467 - IO Rack
  • Metso RKN-359XT - Repair Kit
  • Metso 2.00SB2HKT27A6 - Parker Pneumatic Cylinder
  • Metso D100306 - AIF2mV GEB Module
  • Metso A413757 - AOR4C GEB Module
  • Metso A413754 - AIR8H GEB Module
  • Metso A413767 - AOF2V GEB Module
  • Metso A413742 - BIR82 GEB Module
  • Metso A413744 - BOR82 GEB Module
  • Metso A413753 - AIR8V GEB Module
  • Metso A413752 - AIR8C GEB Module
  • Metso 96511900 - Hydraulic Filter
  • Metso IOP334 - Isolated Digital Input Module
  • Metso 1003894081 - High Flow Oil Filter Cartridge
  • Metso H035506 - Ball Valve Seat Set Kit
  • Metso PDCH2680 - Shaft Sleeve
  • Metso LK-937 - Linkage Kit
  • Metso VAL0353763 - Valmet Pneumatic Cylinder 250PSI
  • Metso APL3037188 - Hydraulic Cylinder 2" Bore
  • Metso 181540 - IOP307 Isolated Analog Input Module
  • Metso LK-2032 - Linkage Kit
  • Metso VAL0207205 - Valmet Automation Power Supply
  • Metso PDCF2680 - Shaft Sleeve
  • Metso 422244-1A - GMB Relay Module Board
  • Metso VAL0356906 - Paper Pneumatic Cylinder
  • Metso RKW-355TT - Jamesbury Repair Kit 8in
  • Metso QN2SP02SXM-BSF - Quartz Valve Control Stonel
  • Metso D201134 - AI8 Analog Input Module
  • Metso APL3032501 - Automation Component
  • Metso D201784L - MBM Backplane
  • Metso M851121 - DMU M2 Module
  • Metso A413310 - Valmet Neles VPU Power Unit
  • Sarianna Metso The Serekh Texts - Hardcover Book
  • Metso 5044i9PS - Pump Impeller
  • Metso 181575 - IOP345 Overspeed Trip Module
  • Metso RKQ-66 - Jamesbury Actuator Diaphragm
  • Metso RKW353XZ - Automation Component
  • Metso PIC-09-50-200 - Automation Component
  • Metso LK-2027 - Linkage Kit
  • Metso XZB10025-011T12 - Moog Valve 9650962700
  • Metso XZB10025-010T12 - Moog Valve 9650965300
  • Metso-SP Transmitter Cable - Operating Unit with 10m Cable
  • Harkila Metso Hybrid - Hunting Jacket Willow Green
  • Metso ND8221/S1 - Neles Valve Positioner
  • Metso METSO10119 - ScreenCheck Component
  • Metso LK-2025 - Linkage Kit
  • Metso A416733 - IQweight External Air Gap Temperature Sensor
  • Metso RKC22MT - Automation Component
  • Metso A413281 - Automation Board
  • Metso LCP9HLY - Stainless Steel Enclosure
  • Metso NP704S/B1S1 - Pneumatic Positioner with I/P Converter
  • Metso BAH3 - Slurry Seal Type
  • Metso A413531-03 - PLC Module Chassis Rack
  • Metso P4610004 - MCAI Communicator Controller
  • Metso QN2AN03HDM - Quartz Valve Positioner Stonel
  • Metso RKW-352-XZ - Automation Component
  • Metso A4300081 - Kajaani LCD Display
  • Metso A428026 7B - Kajaani Rectifier Unit 1
  • Metso 202218 - Kajaani Sensor Power Supply SR 902660
  • Metso 9150 316SS CSTL - Jamesbury 150-2" BN50 Valve
  • Metso 81806 - IOP101 Module
  • Metso STOM000272 - Paper Bushing CR38
  • Metso 1975413 - Chain Hoist Links
  • Metso IMO G053-191597 - Minor Seal Kit
  • Metso VAL0087418 - Cylinder Valmet NTS6LV
  • Metso A413061 - DMU Board VPA 420355-4B
  • Metso P2620-80/25-100 - Automation Component
  • Metso VAL0035292 - Automation Component
  • Metso A413721 - Automation Component
  • Metso ST600 - Automation Component
  • Metso P4500001 - Automation Component
  • Metso SDBX/RA2 - CAT x KVM Extender
  • Metso D201126-DI8 - Digital Input Module
  • Metso D201189L - AI8H Analog Module
  • Metso NA004418 LK1016 - Wafersphere Actuator Mounting Bracket
  • Metso RKN172MTT - Repair Kit
  • Metso MM0311584 - Air Filter Kit RadialSeal
  • Metso 181517 - IOP301 Isolated Analog Input Module
  • Metso RAU3906506 - Automation Component
  • Metso 181208 - IOP332 Digital Input Module
  • Metso A413760 - AIF2C PCB Module
  • Metso 006 1089 36 - Shaft Bearing Seal
  • Metso A413046 - Automation Component
  • Metso VKJ650 - Automation Brake Component
  • Metso LK-1875 - Linkage Kit
  • Metso D201193L - FI4S24 Frequency Input Module
  • Metso D200533 - BIU82 Binary Input Module
  • Metso 500838-M1 - Impeller Pump Release Collar Assembly
  • Metso 2.00SB2ALUS19A - Pneumatic Cylinder 1.375 Stroke
  • Metso D201351 - RES Reserve Module
  • Metso A416100 - IQMoisture Spare Part Kit Halogen Lamp
  • Metso Slurry Pump - Back Liner
  • Metso 7088010042 - Bronze Lantern Ring