ABB GDC801B101 Inverter control cabinet logic board
Clear All Registers - Resets all readings in registers (1 to 9) to zeroSimulate current or voltage This window allows the simulation of current or voltage
injection - injection into the relay.
Select the required module for which the current or voltage
is to be injected.
IInject preset current command button –
Simulates the one time (static) injection of the input current
into selected input of the relay.
Forced Output Activation - Places the simulator in the Forced Output Activation position
(i.e. "forced" trip mode).
Note: In the relay, this position is reached by running through the
relay positions to position zero (with the reset button) and then
pressing the program button down for more than 5 seconds
Turn on/off power switch - Simulates the switching on/off of the power supply to the SPAD
346 C relay
View Clipboard - Display the contents of the clipboardCopy to Clipboard - Copy selected area to the clipboard.
Upon selecting this option, the cursor is
restricted to the SPAJ 115 C relay area.
To select the required area
Press and hold left mouse button at top left
hand corner of required area.
Move mouse to bottom right hand corner of
required area. (a rectangle box is display to
show the selected area)
Release the mouse button.
Note: Click once anywhere to cancel the copy
command
Print Simulator window - Print the contents of the SPAD 346 C window
Print Setup - Change the printer configuration
Exit - Stop running the simulator program

Show Toolbar/Show Status bar - Displays/removes the toolbar on the screen depending
on whether it is currently removed/shown respectively.
Change LED Colours - Change the colours of the background and LED's to suit
individual screens and preferences
Click on the appropriate box to change the
corresponding colour
Click on the "Apply changes to Simulator" button to
confirm the changes made
Click on the "Apply default colours" button to set all
colours to permanently set defaults
Click on the "Cancel all color changes" button to cancel
all changes made
Change Simulation Speed - Change the speed at which the simulator works. This
allows for adaptations to individual hardware
configurations. When this option is selected, the
following window is shown
Use the left mouse button to click on the left (or right)
arrow to increase (or decrease) the simulation speed.
Alternatively, click (and hold) the flashing box on the
slide and drag it to the required position.
Click OK to confirm the changes made or click
CANCEL to ignore any changes
Change Background - Changes the background colour of the window.
Change to Default Settings - Change all settings to the defaults set when the relay is
shipped from the factory.
WARNING: Selecting this option results in the lost of all
current settings.
Change to Customized Settings - All settings are automatically saves to file when:
1. Power is turned off
2. Program exits
These (current) settings are also automatically loaded
when the program is restarted.
Another (separate) set of settings can be saved by using
the SAVE AS CUSTOMISED SETTINGS option. This
allows the user to keep a set of preferred initialization
settings, which can be, reload at any time using the
CHANGE TO CUSTOMISED SETTINGS option.
Selecting this option results in the lost of all current
settings.