GE IC697MDL671 Interrupt Input Module, 14 points
Note: The currents at +12 and -12 VDC are specified with the serialconnectors open.
Temperature:
Operating: 0 to +50 °C
(Air flow requirement as measured at outside of heatsink is to be
greater than 350 LFM)
Storage: -25 to +80 °C
Relative Humidity: 10% to 90%, noncondensing
VMEbus Interface:
DTB Master: BLT32/BLT64, A32/D32,
A24/D32, A16/D32
DTB Slave: BLT32/BLT64, A32/D32,
A24/D32, A16/D32
Requester: Programmable, BR(3 to 0), ROR,
RWD, BCAP
Interrupt Handler: IH(1 to 7) D8(O)
Interrupter: Programmable, IRQ7* to IRQ1*
Arbiter: SGL, PRI, RRS
BTO: Programmable (4 to 1,024 µs)
Compliance: Rev. C.1
PMC Expansion Site Connector:
5 V signaling, types 1 and 2
32-bit PCI bus, 33 MHz maximum
MTBF: 118,633 hours (Bellcore)
Compatible Products
The VMIVME-7648 can be used with a number of GE Fanuc PMC bus
and VMEbus products.
Floppy/Hard Disk: GE Fanuc produces floppy/hard drive modules to
support the built-in IDE and floppy controller ports.
The VMIVME-7452 provides up to 18.0 Gbyte of hard disk storage and a
3.5-inch 1.44 Mbyte floppy drive. The unit fits into a standard VMEbus
6U single slot form factor. The VMIACC-0562 converts P2 IDE/floppy
signals to 40- and 34-pin headers for use at the rear of the VMEbus
backplane.

PMC Capability: GE Fanuc supports PMC via the onboard PMC
expansion site. This expansion site allows the VMIVME-7648 to take
advantage of the many commercially available PMC boards available
from third-party sources.
CD-ROM Support: Since much of today’s advanced software is
delivered on CD-ROM, the VMIVME-7455 provides CD-ROM capability
within a single 6U VME slot.
VMEbus: The VMIVME-7648 enables access to GE Fanuc’s wealth of
VMEbus products. If you have real world control, monitoring and real
time networking requirements, GE Fanuc has a solution for you. Today’s
system requirements demand state-of-the-art solutions. Our advanced
I/O features such as Built-in-Test, self-test, isolation, digital
autocalibration, and intelligent onboard DSP processing give our
customers those solutions.
The I/O Solution for Your I/O Problem: GE Fanuc’s 18 years of
experience in supplying high performance deterministic controllers for
multiple markets has led to the development of IOWorks software with
features, benefits and capabilities to solve just about any I/O problem.
From PLC alternatives to data servers that support the seamless
interconnection of dissimilar systems, GE Fanuc has the solution for
simple to complex high speed deterministic requirements. IOWorks PC
platforms, target, OS and I/O independency provide the flexibility for
solutions.
Trademarks
MMX is a trademark and Intel and Pentium are registered trademarks of
Intel Corporation. Visual Basic, Visual C++, Windows, and Windows XP
are registered trademarks of Microsoft Corporation. Other registered
trademarks are the property of their respective owners.