Eaton XV-303/XV-313 multi touch display



Eaton XV-303/XV-313 multi touch display

Basic Information

Document information: Released in March 2025, version 01.1, copyright belongs to Eaton Corporation. Reproduction, dissemination, etc. are not allowed without permission.

Equipment Overview

Function: It can be used as an operation and monitoring device, or as an operation and control device with PLC function. It adopts industrial high-resolution capacitive multi touch technology, has an intuitive gesture based user interface, and a powerful graphics processing unit.

Model difference: XV-303 is a front mounted type, while XV-313 is a rear (panel) mounted type.

Display size: There are three widescreen sizes: 7.0 inches, 10.1 inches, and 15.6 inches, with resolutions of 1024x600 pixels and 1366x768 pixels, respectively.

Processor and Memory: Equipped with an 800MHz ARM Cortex-A9 processor, 1GB of internal memory and 128kB of non-volatile data storage, the memory can be expanded through an SD card.

Operating system: Linux operating system is used.

Safety regulations

Personnel qualifications: Installation, operation, maintenance, and repair personnel must possess corresponding qualifications, undergo appropriate training, and understand the hazards and risks related to the equipment.

Precautions before installation: Installation must be carried out by a qualified electrician. Before installation, disconnect the equipment power supply to prevent re triggering, verify isolation from the power supply, grounding and short circuit, cover adjacent live parts, etc.

Equipment specific hazards and prevention

There is a risk of explosion, and it can only be used in non hazardous areas and hazardous areas defined by the ATEX directive in Zone 22 to avoid dangerous impacts.

Improper handling of lithium batteries may cause explosions, and professional equipment disposal is required.

Static discharge may damage components, and static electricity should be released before contacting the equipment.

Non galactic isolated interfaces may damage equipment due to potential differences, and power must be disconnected before connecting and disconnecting connectors.

Installation

Installation location requirements

The environmental temperature, air pressure, humidity, etc. must comply with regulations and avoid direct sunlight and heat sources.

The installation location should ensure that the device controls and connectors are accessible, taking into account the space required for removing the SD card.

There are specific requirements for the installation angle and panel thickness of different models.

Installation steps

Unpack and inspect the equipment for any transportation damage, and verify the contents of the packaging.

The front installation type and the rear installation type have different fixing and sealing methods and steps.

Preparation for operation: Connect the grounding function and pay attention to the specifications of the grounding wire; Connect the power supply by an electrician, paying attention to voltage polarity and requirements.

Debugging

Initial debugging: Configure system settings and install required software packages.

Operation: After connecting to the power supply, the device will start without the need for a separate switch. Lowering the brightness can extend the lifespan of the monitor backlight. In case of any malfunctions, please refer to the troubleshooting section.

External connection

Interface types: including SD card slots, USB host and device interfaces, Ethernet interfaces, RS-232, RS-485, CAN1 interfaces, etc. Different interfaces have corresponding specifications and connection requirements.

Connection precautions: Avoid stray currents, use appropriate cables and correctly assemble terminations, follow relevant standards and instructions.

Troubleshooting

Listed the reasons and solutions for common malfunctions such as device failure to start, monitor dimming, unresponsive or incorrectly responsive touch technology.

Maintenance

Cleaning and maintenance: The equipment is basically maintenance free. When the touch technology gets dirty, it can be cleaned with a clean, soft, and damp cloth, and recalibrated if necessary.

Maintenance: Maintenance requires contacting the supplier or Eaton technical support, and the equipment can only be opened by the manufacturer or authorized center.

Storage, transportation, and disposal: Storage and transportation must comply with environmental conditions, avoid UV light and condensation water, and equipment scrapping must be professionally disposed of, following local recycling regulations.