GE VersaMax 24VDC Input Modules

GE VersaMax 24VDC Input Modules

Product Description

Discrete input modules IC200MDL640 and BXIOID1624 provide two  groups of 8 discrete inputs.  Discrete input module IC200MDL650 (shown below) and BXIOIX3224  provide four groups of 8 discrete inputs.  Inputs in each group can be either positive logic inputs that receive  current from input devices and return the current on the common, or  negative-logic inputs that receive current from the common and return  current to the input device. Input devices are connected between the  input terminals and common terminals.

LED Indicators

Individual green LEDs indicate the on/off state of each input point.  The green OK LED is on when backplane power is present to the  module.

Preinstallation Check

Carefully inspect all shipping containers for damage. If any equipment  is damaged, notify the delivery service immediately. Save the damaged  shipping container for inspection by the delivery service. After  unpacking the equipment, record all serial numbers. Save the shipping  containers and packing material in case it is necessary to transport or  ship any part of the system.

Installation in Hazardous Locations

 EQUIPMENT LABELED WITH REFERENCE TO CLASS I,  GROUPS A, B, C & D, DIV. 2 HAZARDOUS LOCATIONS IS  SUITABLE FOR USE IN CLASS I, DIVISION 2, GROUPS A, B, C,  D OR NON-HAZARDOUS LOCATIONS ONLY  

 WARNING - EXPLOSION HAZARD - SUBSTITUTION OF  COMPONENTS MAY IMPAIR SUITABILITY FOR CLASS I,  DIVISION 2; 

 WARNING - EXPLOSION HAZARD - WHEN IN HAZARDOUS  LOCATIONS, TURN OFF POWER BEFORE REPLACING OR  WIRING MODULES; AND 

 WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT  EQUIPMENT UNLESS POWER HAS BEEN SWITCHED OFF OR  THE AREA IS KNOWN TO BE NONHAZARDOUS.

Configuration Parameters

The module’s basic input on/off response time is 0.5ms.  For some applications, it may be preferable to add additional filtering to  compensate for conditions such as noise spikes or switch bounce. Input  filter times of 0ms, 1.0ms, or 7.0ms are selectable via software  configuration, for total response times of 0.5ms, 1.5ms, and 7.5ms  respectively. The default is 1.0ms filter time

Input Characteristics

Input voltage:0 to +30VDC,+24VDC nominal

On state voltage:+15 to +30VDC

Off state voltage:0 to +5VDC

Configurable filter  time:0 ms, 1.0ms (default), or 7.0ms

Input impedance:10kOhms maximum