ABB 086318-002 PWA memory board
TZIDC DIGITAL POSITIONER | CI/TZIDC/ATEX/IECEX-EN REV. B 33
Operating button functions
Control button Meaning
ENTER • Acknowledge message
• Start an action
• Save in the non-volatile memory
MODE • Choose operating mode (operating level)
• Select parameter group or parameter
(configuration level)
UP direction button
DOWN direction button
Press and hold all four
buttons for 5 s
Reset
Menu levels
The positioner has two operating levels.
Operating level
On the operating level the positioner operates in one of four
possible operating modes (two for automatic control and
two for manual mode). Parameters cannot be changed or
saved on this level.
Configuration level
On this level most of the parameters of the positioner can be
changed locally. The PC is required to change the limit values
for the movement counter, the travel counter, and the userdefined characteristic curve.
On the configuration level the active operating mode is
deactivated. The I/P module is in neutral position. The
control operation is inactive.
NOTICE
Property damage
During external configuration via a PC, the positioner no
longer responds to the set point current. This may lead to
process failures.
• Before any external parameterization, always move the
actuator to the safety position and activate manual
adjustment.
Note
For detailed information on how to parameterize device, consult
the associated operating instructions and/or configuration and
parameterization instructions.

Maintenance
The positioner does not require any maintenance if it is used as
intended under normal operating conditions.
Note
Manipulation by users shall immediately render the warranty for
the device invalid.
To ensure fault-free operation, it is essential that the device is
supplied with instrument air that is free of oil, water, and dust.
9 Recycling and disposal
Note
Products that are marked with the adjacent symbol
may not be disposed of as unsorted municipal waste
(domestic waste).
They should be disposed of through separate
collection of electric and electronic devices.
This product and its packaging are manufactured from materials
that can be recycled by specialist recycling companies.
Bear the following points in mind when disposing of them:
• As of 8/15/2018, this product will be under the open
scope of the WEEE Directive 2012/19/EU and relevant
national laws (for example, ElektroG - Electrical
Equipment Act - in Germany).
• The product must be supplied to a specialist recycling
company. Do not use municipal waste collection points.
These may be used for privately used products only in
accordance with WEEE Directive 2012/19/EU.
• If there is no possibility to dispose of the old equipment
properly, our Service can take care of its pick-up and
disposal for a fee.
TZIDC DIGITAL POSITIONER | CI/TZIDC/ATEX/IECEX-EN REV. B 35
Change from two to one column
11 Appendix
Return form
Statement on the contamination of devices and components
Repair and/or maintenance work will only be performed on devices and components if a statement form has been completed and
submitted.
Otherwise, the device/component returned may be rejected. This statement form may only be completed and signed by authorized
specialist personnel employed by the operator.
Customer details:
Company:
Address:
Contact person: Telephone:
Fax: Email:
Device details:
Type: Serial no.:
Reason for the return/description of the defect:
Was this device used in conjunction with substances which pose a threat or risk to health?
Yes No
If yes, which type of contamination (please place an X next to the applicable items):
biological corrosive / irritating combustible (highly / extremely
combustible)
toxic explosive other toxic substances
radioactive
Which substances have come into contact with the device?
We hereby state that the devices/components shipped have been cleaned and are free from any dangerous or poisonous substances.