GE 5136-DN-VME DeviceNet Master/Slave module



GE 5136-DN-VME DeviceNet Master/Slave module

PAC70 system and 90-70 system serve as the main stations of DeviceNet:

The Pac70 system and the 90-70 system use the same template, which can serve as both the master and master of DeviceNet

From DeviceNet. The PAC system and 90-70 system use the 5136-DN-VME card to communicate with the DeviceNet protocol

The communication card is inserted into the rack of the PAC70 system or 90-70 system, occupying a slot.

Order number

5136-DN-VME

EEPROM (required)

Module Description

PAC70 system, use DeviceNet Master/Slave module for 90-70 system

Network speed

500K，250K，125K

Network topology structure

Bus type substation with restrictions (Trunkline/Drop Line)

Network cable

Two Shielded pairs-Common axis w/drain wire in Center

Network power supply (for nodes)

Normal 24 VDC+/-% 4

Maximum number of nodes

sixty-four

transmission distance 

100m (500K), 250m (250K), 500m (125K) meters

P4

FAIL

PASS

Jumper: Used to select whether the module is bootstrapped from RAM or from

EPROM bootstrap

two

DIP switch SW1: for module settings

five

VME bus address

CN1

Name 8

three

Module failure or indicator light:

COMM

Indicator light for module initialization

HEALTH

Lv 8

SW

four

four

Communication and health indicator lights:

OPTIONAL EPROM

Used to indicate whether communication is normal

two

5 Bus connector: DeviceNet bus connector.

DeviceNet network communication

Characteristics of 5136-DN-VME:

Supports all standard DeviceNet communication rates (125K, 250K, 500K).

Each slave station has a maximum of 255 bytes of input/255 bytes of output.

Support UCMM.

Support Explicit information and I/O connections: Polling, Strobe, Change of State

(COS), Cyclic I/O.

Precautions for setting up 5136-DN-VME board:

1. Jumper P4 must be set to EPROM.

RAM

EPROM

P4

If there is only one 5136-DN-VME, set SW1 as follows:

SW

two

three

four

five

six

eight

nine

ten

ON/OFF

ON

OFF

ON

OFF

OFF

OFF

ON

ON

ON

ON

If there is a second card, set SW1 as follows:

SW

two

three

four

five

six

eight

nine

ten

ON/OFF

ON

OFF

OFF

ON

ON

ON

ON

ON

ON

ON

4. Using GE Fanuc programming software

Configure this network card:

Module Catalog

Use ME software for 5136-DN-VME

Communications | Bus Expansion | Bus Conballer|Intelligent Option |

Select a slot:

Discrete Input| Discrete Dutput| Analog Irput| Analog Output VME

OK

Catalog Number

Desription

(1) Add Module:

BAD PTYVME

3id Party VME

Cancel

GENERICIO

VME-3rd Party VME