K-WANG
Can communicate with devices such as barcode readers (RS232C) and network inverters (RS485) using RS232C and RS485
Row data input and output, ASCII and HEX (binary) communication can be achieved through radar programs.
OEMAX-NX700-UM009A-KO-P-Serial communication unit
Unit is equipped with dual channels (optional RS232C, RS485).
2. Data input/output can be completed with simple sequence commands.
When reading data from SCU, use PLC application command [READ], and when writing data to SCU, use application command
Execute with [WRT]. Post processing is run by shared memory between CPU UNIT and SCU, so complex programs
No need to create.
3. SCU Units have added RS-485 network functionality to the previously used N series SDU modules,
Expanded its usefulness.
4. The network can be constructed using RS232C communication and RS485 communication.
Can input/output data with RS232 devices:
Can be connected to IDX displays, instruments, barcode readers, printers, etc. for data input/output
Data can be input/output through the network with h RS485 device:
Connect to temperature controller, network frequency converter, and network servo through the network
5. Can be installed indefinitely in the PLC slot, transmitting 500 bytes at a time.
6. The available transmission codes can also be ASCII or HEX (Binary).
7. During communication, the terminal code can be freely set to PLC Ryder commands.
1 Specification and product configuration
NX70 PLC
SCU unit
(NX70-SCU)
one
Interface RS232 C/RS485 2 ports
transmission speed
Selected by DSW1 and DSW2
1) When using RS232C: 300/600/1200/4800/9600/19200/38400 bps
2) When using RS485: 4800/9600/19200/38400 bps
Communication Half Duplex
Synchronous Asynchronous (START-STOP)
When using RS232C transmission distance: 15 meters (MAX), when using RS485: 1.2 kilometers
Transfer code ASCII or HEX (Binary)
Data transmission format
STOP bit 1-bit/2-bit
Peritiyu/None (even/odd)
Data length of 7 bits/8 bits
The data transmission order starts from bit 0 and is sent in character units
Message unit for sending unit to terminal code (variable length)
Maximum message length MAX.500 Byte/frame (including end-to-end code)
CPU Unity
Interface
Shared memory method
For the. N series: The application commands F150 (READ) and F151 (WRT) can be read and written
For the. NPlus series: the application commands "READ" and "WHITE" can read and write
I/O allocation input 16 points, output 16 points
Terminal code settings: ① Choose from the three types of cr ② cr+LF ③ ETX, or set any code in shared memory
Initial code Initial code Yes/No
Other special control terminal code Cut transmission and reception mode (controlled by Siquens command) for easy printer output.
Soft reset (controlled by Siquens command)
User name | Member Level | Quantity | Specification | Purchase Date |
---|